|
Posted by ed on July 18, 2005 at 16:38:25: In Reply to: Posted by on July 18, 2005 at 08:09:12: : I changed my 6 volt 47 CJ2A jeep with a floor start to a 12 volt Alt. After hooking up the batt jeep starts fine. But, batt is dead after sitting for 24 HR. Any idea's where the power drain might be?
Be sure that your switch is shutting off. Then check the wire that is hooked to the line side of the floor switch. The best way to figure it out iss to see what is hooked thru the switch and what is not. The things that are not thru the switch disconnect each one individually and see if they throw an arc. If one does, trace it out and see where it goes such as the heater lights radio.etc.
|