Posted by geoff on August 08, 2005 at 16:35:48: In Reply to: Posted by on May 19, 2005 at 08:41:59: : : : I'm using a corrugated pipe to mock-up my 80 Vette exhaust (because of extensive work) and you can bend it to any curve you want. I'm only using it to shape the two pipes that have to be fabed up to fit the frame. Not sure if this would help you. You could cut it off and have an exhaust shop bend a section to fit. Besure you can find the correct diameter first. : : Sorry to say this is a common porblem with all reopo tubs. I found if I trimmed the rubber where the neck sticks through the hole then it worked OK. I have been told this has been fixed along with the correct placement of the filler neck on mew repos. Anyone seen inprovemets? Bill : : Good Luck
|