Posted by Mike N on October 30, 2002 at 08:59:02: In Reply to: Posted by on October 28, 2002 at 09:49:10: Thanks for the input. Vern, I did use Rick's guide, an exceptional bit of reference. No new bearings went in, but I suspect the light coatings of spray sealer on the old shims added up to cause the binding. G, everything turns freely until I tighten down the yoke. Doing a 'test' tighten without the yoke will eliminate the felt as a factor. It's all still a bench prject at this point, so it's simple enuf to re-do a lil of what's been done. Thanks Mike
|