Monarch Governor Control Arm |
Post Reply |
Author | |
timcj2a
Member Sponsor Member Joined: 19 July 2005 Location: Chula Vista, CA. Status: Offline Points: 801 |
Post Options
Thanks(0)
Posted: 27 May 2017 at 7:08pm |
I am posting this in the How To Information section, based on a request for a pattern from CJ2A Page member, Max, in Argentina.
I'm not a machinist or metalworker, however here is a pattern for the Monarch Governor Control Arm in a PDF file, if anyone else needs to make their own. I traced the original arm, imported it into MacDraft Pro, and added dimensions and notes. It is scaled 1" = 1". I printed a copy and it came out pretty close to the original dimensions. The pic below is not scaled, therefore don't use it. The link to the working pdf is below that. Tim Edited by timcj2a - 27 May 2017 at 9:29pm |
|
Max
Member Joined: 11 Sep. 2015 Location: Buenos Aires Status: Offline Points: 101 |
Post Options
Thanks(0)
|
Thanks Tim, it has been very useful.
|
|
Max
CJ2A 110861 |
|
timcj2a
Member Sponsor Member Joined: 19 July 2005 Location: Chula Vista, CA. Status: Offline Points: 801 |
Post Options
Thanks(0)
|
I'm glad it's been helpful. Make sure to post photos when you are finished.
Tim
|
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |