Posted by Bart on December 13, 2002 at 17:40:08: In Reply to: Posted by on December 13, 2002 at 13:39:45:
: This link is from someone on the G503 site and shows what I believe everyone is looking for. Be real cautious about these photos and measurements: Three rods specific to 2A are not shown. Door clamp/hinge for 2A not shown. 2A Side rail rods not shown.(2) 2A center spacer rod not shown (1) Vertical door jamb rods not shown.(2) The two rear rods (rails) and measurements are not shown. (2) Two photos are misleading because one bow has been cut short and another is badly bent. Some measurements are wrong. Brackets are unclear in the photos, so you cannot make them correctly. It gives you a rough but somewhat incorrect view of the bows. You cannot make them correctly from these photos and measurements unless you have a correct set available to compare. No doubt the intentions of the author are the best, but there is too much info missing and incorrect to try it from these photos and instructions. Sorry folks, Bart
|